Upgrading Windows 10 1511 to higher version with DisplayLink installed

Cas · 06-07-2017, 12:00 PM

Hello Alban,

Thanks for your response. I am aware of the way Windows 10 "upgrades", sorry for using the confusing terminology

The Windows Update driver update is disabled in our corporate environment, so the DisplayLink driver does not get installed via Windows Update.

We use the method you describe, 1607 "upgrade" is ready, then we run the RS1 MSI, so the TH2 MSI is left untouched on the machine, is this OK?
On some systems immediately after the RS1 MSI was succesfull, proof of this from the MSI log we create during install, another MSIexec process is started which removes the software again. We have been trying to figure out why, could one of the Custom Actions in the RS1 MSI cause this?

Thanks again,
Cas

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-07-2017, 12:00 PM	#3
Cas Junior Member Join Date: Jun 2017 Posts: 3	Hello Alban, Thanks for your response. I am aware of the way Windows 10 "upgrades", sorry for using the confusing terminology The Windows Update driver update is disabled in our corporate environment, so the DisplayLink driver does not get installed via Windows Update. We use the method you describe, 1607 "upgrade" is ready, then we run the RS1 MSI, so the TH2 MSI is left untouched on the machine, is this OK? On some systems immediately after the RS1 MSI was succesfull, proof of this from the MSI log we create during install, another MSIexec process is started which removes the software again. We have been trying to figure out why, could one of the Custom Actions in the RS1 MSI cause this? Thanks again, Cas