USB-C to HDMI dock - no video controls or LUT support

RadioPhil · 08-03-2018, 04:33 PM

I read that review before deciding to buy this monitor. My favorite sentence is "With only minor corrections to the settings, the monitor achieves near-perfect color results." The results the review refers to are after calibration, though.

I tested my DisplayLink device again, this time resetting the monitor to its defaults. Now, black and white levels are spot on - no clipping or crushing. But my x-rite device cannot complete its calibration because it cannot save the LUT it created.

My device that uses DisplayLink technology is WavLink WL-UG69DK1 Rev B.
Device Manager properties, Details tab, Hardware IDs property, says
USB\VID_17E9&PID_6000&REV_0106&MI_00
USB\VID_17E9&PID_6000&MI_00

I hope I have hardware that will allow me to calibrate my monitor. I can make whatever registry changes you suggest.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-03-2018, 04:33 PM	#5
RadioPhil Junior Member Join Date: Jul 2018 Posts: 7	I read that review before deciding to buy this monitor. My favorite sentence is "With only minor corrections to the settings, the monitor achieves near-perfect color results." The results the review refers to are after calibration, though. I tested my DisplayLink device again, this time resetting the monitor to its defaults. Now, black and white levels are spot on - no clipping or crushing. But my x-rite device cannot complete its calibration because it cannot save the LUT it created. My device that uses DisplayLink technology is WavLink WL-UG69DK1 Rev B. Device Manager properties, Details tab, Hardware IDs property, says USB\VID_17E9&PID_6000&REV_0106&MI_00 USB\VID_17E9&PID_6000&MI_00 I hope I have hardware that will allow me to calibrate my monitor. I can make whatever registry changes you suggest.