Advice for maximising Windows Embedded Standard 7 success

ThoricSolutions · 02-12-2019, 01:52 PM

Hi Alban,
I've not yet purchased the hardware, I wanted to learn as much as possible about the potential for success before investing, so I haven't tried any drivers yet.

The target is probably going to be a National Instrument Industrial Controller IC-3171:
http://www.ni.com/pdf/manuals/376361b.pdf

These are Intel Celeron 1.9 GHz WES7 systems, I'm told the image is very close to full Windows 7 Pro.

The device supports 2 native DisplayPort screens, I wish to add two more to make a total of four portrait mode monitors, each showing a window generated by my own software. The Portrait Mode element is important, and I'm assuming I can configure this within the Windows settings for the DisplayLink devices, and once set it will remain configured as such?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-12-2019, 01:52 PM	#4
ThoricSolutions Junior Member Join Date: Jan 2019 Posts: 3	Hi Alban, I've not yet purchased the hardware, I wanted to learn as much as possible about the potential for success before investing, so I haven't tried any drivers yet. The target is probably going to be a National Instrument Industrial Controller IC-3171: http://www.ni.com/pdf/manuals/376361b.pdf These are Intel Celeron 1.9 GHz WES7 systems, I'm told the image is very close to full Windows 7 Pro. The device supports 2 native DisplayPort screens, I wish to add two more to make a total of four portrait mode monitors, each showing a window generated by my own software. The Portrait Mode element is important, and I'm assuming I can configure this within the Windows settings for the DisplayLink devices, and once set it will remain configured as such?