|
|
|
07-23-2020, 11:54 AM
|
#1 |
|
DisplayLink Tech Support
Join Date: Apr 2020
Posts: 461
|
Hello,
Were you able to successfully go through the steps that I suggested earlier? If yes, could you send another set of logfiles that will show any other possible issues? Thank you, Katarzyna
__________________
Katarzyna Czaja DisplayLink Check DisplayLink powered products here. Basic troubleshooting FAQs: |
|
|
|
07-23-2020, 03:57 PM
|
#2 |
|
Junior Member
Join Date: Jul 2020
Posts: 6
|
No. It does not appear in Security & Privacy at all. I also do not get a popup when installing saying blocked or anything else even after a clean driver install.
|
|
|
|
|
07-24-2020, 07:10 AM
|
#3 |
|
DisplayLink Tech Support
Join Date: Apr 2020
Posts: 461
|
Hello,
Post installation you will not receive any notification that the kext has been blocked. If you see in System Report->Extensions the section where is says Loaded and it says No there that means that the driver is blocked. You have to make sure that right after you install it you go to Security & Privacy and you enable it it as this option is available only for 30 minutes post the installation. After that it will not show that option at all. Can you please double check if after reinstalling it shows? Thank you, Katarzyna
__________________
Katarzyna Czaja DisplayLink Check DisplayLink powered products here. Basic troubleshooting FAQs: |
|
|
|
|
07-24-2020, 12:39 PM
|
#4 |
|
Junior Member
Join Date: Jul 2020
Posts: 6
|
It shows on the list as already allowed without doing anything after I install.
|
|
|
|
|
07-24-2020, 12:46 PM
|
#5 | |
|
Junior Member
Join Date: Jul 2020
Posts: 1
|
Dual monitor display goes black every few seconds after IOS update, I have installed.
Quote:
|
|
|
|
|
|
07-28-2020, 04:11 PM
|
#6 |
|
Junior Member
Join Date: Jul 2020
Posts: 6
|
Upgrading to 10.15.6 fixed the issue. Thanks
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Hybrid Mode
