Confused on Night Light for Dell D6000 Dock

[BowserLink]

Originally Posted by AlbanRampon

Good afternoon,

End products do not only have a DisplayLink chip in them and other components impact the feature set. That is the case of the Dell D6000.

The night light feature stays in beta state as it has some issues.

For the Dell D6000, it would work on the HDMI or DP outputs. If using a DisplayPort output, you need to connect to a DisplayPort monitor, or use an *active* converter. I believe your case does not work because you use a passive adapter.

Kind regards,
Alban

Yes, I'm using a passive DisplayPort to HDMI cable. I will try an active Converter or Active cable. Is there one that is recommended?

[AlbanRampon]

Before you purchase additional hardware, I'd like to make sure you're not going to meet issues.
Would you mind using our customer support tool (see my forum signature for link) and post the .EDID file in your DisplayLink folder created on the desktop for the display you wish to connect through that adapter? It will give me the monitor characteristics.
Kind regards,
Alban

[BowserLink]

Originally Posted by AlbanRampon

Before you purchase additional hardware, I'd like to make sure you're not going to meet issues.
Would you mind using our customer support tool (see my forum signature for link) and post the .EDID file in your DisplayLink folder created on the desktop for the display you wish to connect through that adapter? It will give me the monitor characteristics.
Kind regards,
Alban

Thanks for the response. I ran the "Windows DisplayLink Support Tool" and I cannot find any .EDID files in the DisplayLink folder on my desktop. Was this the correct tool? (I ran it as admin and enabled the two advanced options).

Thank you

[AlbanRampon]

It is the correct tool and the files should be both in the archive and in the subfolder with date and time of collection.
Alternatively, provided you have connected the display you wish to check about, the original location of the file is C:\Windows\Temp\DisplayLink. The file name starts with the name and model of monitor, followed by serial number before .edid.
Kind regards,
Alban

[BowserLink]

Originally Posted by AlbanRampon

It is the correct tool and the files should be both in the archive and in the subfolder with date and time of collection.
Alternatively, provided you have connected the display you wish to check about, the original location of the file is C:\Windows\Temp\DisplayLink. The file name starts with the name and model of monitor, followed by serial number before .edid.
Kind regards,
Alban

OK, the *.EDID files were in the C:\windows\Temp folder. I have attached them as a ZIP file.

[AlbanRampon]

Thank you. I can confirm the Viewsonic VX2452 will be fine with the beta night mode, through an active DP->HDMI adapter, or through the Dell D6000 HDMI output.

[BowserLink]

Originally Posted by AlbanRampon

Thank you. I can confirm the Viewsonic VX2452 will be fine with the beta night mode, through an active DP->HDMI adapter, or through the Dell D6000 HDMI output.

Thank you. I'll purchase the cables and test it out. Thank you again for the attention to detail.