Go Back   DisplayLink Forum > DisplayLink Graphics Technology > Linux and Open Source

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 10-25-2022, 07:39 PM   #5
kahennig
Junior Member
 
Join Date: Oct 2022
Posts: 1
Default

Same here, can't get it to work either.

--
UPDATE.

I spent a few minutes taking a look at my syslog and found this:

Oct 28 09:35:04 khennig sh[11525]: modprobe: ERROR: could not insert 'evdi': Key was rejected by service
Oct 28 09:35:04 khennig systemd[1]: displaylink-driver.service: Control process exited, code=exited, status=1/FAILURE
Oct 28 09:35:04 khennig systemd[1]: displaylink-driver.service: Failed with result 'exit-code'.
Oct 28 09:35:04 khennig systemd[1]: Failed to start DisplayLink Driver Service.

Did this:

// Not sure if these steps were really necessary

sudo displaylink-installer uninstall

Reboot

// not sure which version of evdi To uninstall... so just uninstalled both I had on the machine
sudo dkms remove evdi/1.11.0 --all -q
sudo dkms remove evdi/1.12.0+dfsg --all -q

sudo apt install --reinstall linux-headers-$(uname -r)

reinstall the displaylink driver and reboot.

---

Then disabled secureboot and the monitors hooked up to my displaylink hub are working again.

This does not seem to be the same problem the OP had.
Just wanted to let you know that it's possible to get the drivers to work on 22.10.

Hope you find a way to fix your issue.

Kind Regards.

PD: I installed version 5.6.1 of the drivers.

Last edited by kahennig; 10-28-2022 at 12:49 PM.
kahennig is offline   Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 11:45 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.