Only allows 1 display after 13.3.1 update

jakeave · 05-26-2023, 04:28 PM

I was having a similar issue, and in the System Setting > Displays, I saw that both of my monitors were being detected, but only one was working. It turns out that when I updated my computer, it reset the Refresh rates to 75hz, but my docking station only supports 60hz via USB. So changing my second monitor to 60hz fixed the issue immediately.

cokeefe · 05-27-2023, 05:10 PM

I just bought the doc, am running Ventura 13.4 and all newly installed software, and it only recognizes a single display from my MacBook Air M2. Very frustrating.

05-26-2023, 04:28 PM	#1
jakeave Junior Member Join Date: May 2023 Posts: 1	Double check the refresh rate I was having a similar issue, and in the System Setting > Displays, I saw that both of my monitors were being detected, but only one was working. It turns out that when I updated my computer, it reset the Refresh rates to 75hz, but my docking station only supports 60hz via USB. So changing my second monitor to 60hz fixed the issue immediately.

05-27-2023, 05:10 PM	#2
cokeefe Junior Member Join Date: May 2023 Posts: 1	1 display only I just bought the doc, am running Ventura 13.4 and all newly installed software, and it only recognizes a single display from my MacBook Air M2. Very frustrating.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode