Issu with 5K Setup

Davkus · 11-27-2025, 02:15 PM

Interesting. I will check that. Yesterday there were no signal when im attaching only DP to DP. Then i thought, I need to go to dual DP to DP AND HDMI. Didn't see this config yet, which I build yesterday evening. So let me give you an update when I checked this later.
You connecting HDMI to HDMI, correct?

My mac wasn't powered when I attached the USB-C, this is also correct?

Thanks so far!

Szymon · 11-27-2025, 08:28 PM

I checked both DP to DP and HDMI do HDMI. Good luck!

It doesn't matter if your Mac is powered or not when you connect USB-C.

Regards,
Szymon

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-27-2025, 02:15 PM	#1
Davkus Junior Member Join Date: Nov 2025 Posts: 3	Interesting. I will check that. Yesterday there were no signal when im attaching only DP to DP. Then i thought, I need to go to dual DP to DP AND HDMI. Didn't see this config yet, which I build yesterday evening. So let me give you an update when I checked this later. You connecting HDMI to HDMI, correct? My mac wasn't powered when I attached the USB-C, this is also correct? Thanks so far!

11-27-2025, 08:28 PM	#2
Szymon DisplayLink Tech Support Join Date: Feb 2010 Posts: 270	I checked both DP to DP and HDMI do HDMI. Good luck! It doesn't matter if your Mac is powered or not when you connect USB-C. Regards, Szymon