|
11-13-2018, 09:03 AM | #1 |
Junior Member
Join Date: Nov 2018
Posts: 4
|
I have tried multiple times to post a new thread with no luck
don't know if its a moderator issue Here is my original post --------------------------------- I have an Early 2011 Macbook Pro running High Sierra 10.13.6 I have three external monitors 2 BenQ BL2480's, 1 of which runs from a thunderbolt to HDMI and the other that runs through a cable matters USB to HDMI converter and 1 AOC e1649Fwu which runs through USB So 1 of the BenQ's and the AOC both run using the latest DisplayLink 4.3.1 USB driver. All three screens work, however the AOC will only display in clone mode of my main screen How do I stop clone mode and extend all three as individual monitor screens? |
12-03-2018, 01:01 PM | #2 | |
Junior Member
Join Date: Aug 2018
Posts: 27
|
Quote:
This has been going on for *months* now with no clear solution, if it isn't workable again by February I'm going to just have to remove all the DisplayLink hardware I have altogether and find an alternate way to use my setup. So far I've sporadically had:
It's "ok" for now, but I'm pretty close to just scrapping whole setup. TL;DR: You can only use one DL connector for an output, any others will be clones until they fix something / get Apple to fix something. Until then, I'm not buying or recommending we buy any more products with DL inside. |
|
|
|