3 Monitors not displaying after restart

[Rtaylor]

Ok I updated it, and so far so good.

[frankinbahia]

I have the same problem -- 3 monitors, one connected directly to a dock, the other two with UGA-125's, and only one of the UGA's will connect. I tried a complete uninstall, then reinstall with 6.3M1, but all three monitors were now black.

I have another laptop, the same model, in which I have 6.2M0 installed, and the three monitors work normally. So I again uninstalled on the problem laptop and installed 6.3M0. Same results: only 2 of the three monitors work.

I've attached the log files for the problem laptop, and also (for comparison) the files from the laptop where everything works fine.

[Wim]

Originally Posted by frankinbahia

I have the same problem -- 3 monitors, one connected directly to a dock, the other two with UGA-125's, and only one of the UGA's will connect. I tried a complete uninstall, then reinstall with 6.3M1, but all three monitors were now black.

I have another laptop, the same model, in which I have 6.2M0 installed, and the three monitors work normally. So I again uninstalled on the problem laptop and installed 6.3M0. Same results: only 2 of the three monitors work.

I've attached the log files for the problem laptop, and also (for comparison) the files from the laptop where everything works fine.

2 suggestions:

Try updating the Intel Primary graphics card drivers. They are from 2010 and could cause issues when used with DisplayLink
Update to v6.3 M1.

Hopefully doing those 2 things should solve the issue.

Wim

[frankinbahia]

As noted in my previous post, M1 did not work.
Also, according to the laptop manufacturer, my display driver is current.

Other suggestions??