Go Back   DisplayLink Forum > DisplayLink Graphics Technology > Windows Software

Thread Tools Search this Thread Display Modes
Old 07-18-2013, 05:42 PM   #1
Junior Member
Join Date: Jul 2013
Posts: 1
Default Lenovo Carbon X1 Touch - Display disconnections/flicker

I have a Windows 8 (not 8.1) Lenovo Carbon X1 Touch with the latest video and drivers installed connecting to a Targus ACP70USZ DisplayLink device. I installed the DisplayLink software and attached the device, which worked well for a short while but ultimately started to flicker wildly and disconnect from the secondary monitor. Once the flickering starts the monitors resize, refresh and attempt to connect again. I have connected over DVI, VGA and HDMI (HDMI is my go to config). I have three monitors I have tested this with - all of which have the same issue after a period of about an hour. The experience is, let's just say - unusable. Can anyone assist with a recommendation on how to resolve this? I just updated to the 7.3 DisplayLink software and ran into the same issues. I'm about to return the device, but wanted to check first. Thanks!

joely is offline   Reply With Quote
Old 07-19-2013, 12:48 PM   #2
Senior Member
Join Date: Jan 2012
Posts: 1,523


Please run through these steps:

If the issue persists please post the logs - details for how can be found here:

JamesH is offline   Reply With Quote

carbon x1, lenovo, targus

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 09:02 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.