06-26-2012, 10:12 PM | #1 |
Junior Member
Join Date: Jun 2012
Posts: 1
|
Qwaves no video
I have a qwaves USB device. I got it working for a while then it stopped working, no matter what I done it would not work.
I installed it on a laptop and it worked for a day and then stopped. I downloaded and installed the latest version but without luck. Qwaves reports that both sender/receiver are paired and well within range (full signal). The display manager finds the monitor and even reports it's name in the settings but it will not display anything. In fact the monitor says it is not receiving any signal and powers off after a while. Any suggestions? |
06-30-2012, 12:12 PM | #2 |
Senior Member
Join Date: Feb 2009
Posts: 1,561
|
If the software thinks there is a DisplayLink screen connected and you can drag Windows over to it (you can check by opening Windows Display Properties), then this sounds like a problem with the video cable, or a resolution selected in Windows that is not supported by the TV.
Wim |
Thread Tools | Search this Thread |
Display Modes | |
|
|