Firmware to fix bricked DL-165 with USB ID 8060?

Lope · 03-30-2014, 03:58 PM

I've been using 2 DL-165 adapters for a few months on Ubuntu with kernel 3.9.

Today one stopped working. I've tried all the tricks to get it working (plugging it into the USB port without a monitor attached) etc. But it still has the USB ID of 8060.

Can I update the firmware.
This is an expensive brick.

The displaylink KB article says it's the seller's problem, however, the seller on ebay only accepts returns within 30 days.

Displaylink should take responsibility for this and fix it somehow instead of passing the buck?

24 threads containing the phrase 8060

JamesH · 03-31-2014, 10:04 AM

No, this means the hardware has been incorrectly programmed.

This is not the fault of DisplayLink.

03-30-2014, 03:58 PM	#1
Lope Junior Member Join Date: May 2013 Posts: 6	Firmware to fix bricked DL-165 with USB ID 8060? I've been using 2 DL-165 adapters for a few months on Ubuntu with kernel 3.9. Today one stopped working. I've tried all the tricks to get it working (plugging it into the USB port without a monitor attached) etc. But it still has the USB ID of 8060. Can I update the firmware. This is an expensive brick. The displaylink KB article says it's the seller's problem, however, the seller on ebay only accepts returns within 30 days. Displaylink should take responsibility for this and fix it somehow instead of passing the buck? 24 threads containing the phrase 8060 Last edited by Lope; 03-30-2014 at 04:07 PM.

03-31-2014, 10:04 AM	#2
JamesH Senior Member Join Date: Jan 2012 Posts: 1,523	No, this means the hardware has been incorrectly programmed. This is not the fault of DisplayLink.