DisplayLink Forum - View Single Post - Display port doesn't worked for MacOS 10.15.4

nessoft · 04-09-2020, 10:34 AM

This issue have been resolved. I've found that this issue is about DisplayLinkManager extension can't be loaded. Here is is steps.

1. Uninstall your DisplayLink driver.
2. Restart, press and hold down Command + R keys immediately upon its redirect to Recovery mode.
3. Run the command

Code:

csrutil disable

4. Restart your Mac, after the OS is loaded, run the command

Code:

sudo kextcache -invalidate /

5. Install your DisplayLink driver.
6. Run the command in #4 once again.
7. Repeat step in #2
8. Run the command

Code:

csrutil enable

9. Restart your, the DisplayLink extension should be loaded.

Hopefully, this would you guys who faced this issue.

04-09-2020, 10:34 AM	#3
nessoft Junior Member Join Date: Apr 2020 Posts: 3	This issue have been resolved. I've found that this issue is about DisplayLinkManager extension can't be loaded. Here is is steps. 1. Uninstall your DisplayLink driver. 2. Restart, press and hold down Command + R keys immediately upon its redirect to Recovery mode. 3. Run the command Code: csrutil disable 4. Restart your Mac, after the OS is loaded, run the command Code: sudo kextcache -invalidate / 5. Install your DisplayLink driver. 6. Run the command in #4 once again. 7. Repeat step in #2 8. Run the command Code: csrutil enable 9. Restart your, the DisplayLink extension should be loaded. Hopefully, this would you guys who faced this issue.