Windows 8 (64 bit RTM version) works well with V7.0 B1 DisplayLink beta

tinkererguy · 09-08-2012, 06:13 AM

Odd, on Windows 8, in Device Manager, the usual tones when you add or remove hardware to the USB ports I'm trying to get the dock working from work fine, such as inserting a thumb drive. But when hooking the dock up, absolutely no sound, even though a monitor is attached to the DVI output and the monitor is on. Doesn't matter if I use USB 2 or USB 3 ports on laptop.

Even stranger, plug same dock into an old USB 2.0 computer, and it makes the usual hardware discovery noises, and finds the USB 3.0 Dock devices.

Red light/power was on in all cases.

Any ideas? Trying to get the new firmware there from Lenovo as well:
http://support.lenovo.com/en_US/guid...DocID=UM014961

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-08-2012, 06:13 AM	#6
tinkererguy Member Join Date: Jul 2012 Posts: 33	Odd, on Windows 8, in Device Manager, the usual tones when you add or remove hardware to the USB ports I'm trying to get the dock working from work fine, such as inserting a thumb drive. But when hooking the dock up, absolutely no sound, even though a monitor is attached to the DVI output and the monitor is on. Doesn't matter if I use USB 2 or USB 3 ports on laptop. Even stranger, plug same dock into an old USB 2.0 computer, and it makes the usual hardware discovery noises, and finds the USB 3.0 Dock devices. Red light/power was on in all cases. Any ideas? Trying to get the new firmware there from Lenovo as well: http://support.lenovo.com/en_US/guid...DocID=UM014961