DisplayLink Driver 1.4 causes system crash

isset · 10-27-2017, 01:40 PM

Hi,

the monitor works, but when I open the "Configure Display" tool, the mouse gets stuck and starts "blinking". You can also make Xubuntu open it upon a new device being connected, then I even can configure the monitor, but after a couple of seconds the same behaviour occurs.

I can't swtich to a terminal or do anything else (ctrl+alt+fX), hence I have to do a hard reset.

Best Regards
isset

10-27-2017, 01:40 PM	#3
isset Junior Member Join Date: Oct 2017 Posts: 4	Hi, the monitor works, but when I open the "Configure Display" tool, the mouse gets stuck and starts "blinking". You can also make Xubuntu open it upon a new device being connected, then I even can configure the monitor, but after a couple of seconds the same behaviour occurs. I can't swtich to a terminal or do anything else (ctrl+alt+fX), hence I have to do a hard reset. Best Regards isset