|
11-29-2021, 05:34 PM
|
#1 |
|
Junior Member
Join Date: Nov 2021
Posts: 2
|
big sur on 1.6.0
Since last week, which was before I upgraded this morning to the beta 1.6.0 driver, I haven't been able to use my external monitor on my M1. The monitor is detected as HDMI and I got it going for a little while when the monitor was plugged directly into the second USB-C port but that was only once. It's never worked since then in my external USB hub (powered), which was working fine until recently.
Next steps for troubleshooting? |
|
|
|
11-30-2021, 08:54 AM
|
#2 |
|
DisplayLink Tech Support
Join Date: Apr 2020
Posts: 461
|
Hello,
Thank you for reaching out! What is the monitor that you have exactly? Also you mentioned that it is detected as HDMI but it is connected to USB-C - is it a USB-C monitor connected directly into the computer? Best regards, Katarzyna
__________________
Katarzyna Czaja DisplayLink Check DisplayLink powered products here. Basic troubleshooting FAQs: |
|
|
|
|
11-30-2021, 12:32 PM
|
#3 | ||
|
Junior Member
Join Date: Nov 2021
Posts: 2
|
Hi,
Quote:
Quote:
It is an HDMI monitor that plugs into an xebec displaylink adapter that provides both power via a USB-C port on the monitor and audio+video via a mini HDMI port. The other end of the displaylink adapter has a single USB-A port which plugs into either an external USB hub and then laptop or gets converted again back to USB-C before plugging directly into the laptop. |
||
|
|
|
 |
|
|
Linear Mode
