Docking station not working correctly

TargusLevel3 · 10-03-2014, 04:48 PM

Laurence,

I suspect you have a dodgy dock. That is, some ACP70 have an inductor value that has drifted over time enabling a ringing on a low power input rail to the DisplayLink device that will at times start and others not, an intermittent.

I recommend you exchange the dock for a new one. Targus' factory has modified the hardware and fixed the issue.

If it is not an ACP70, then post back.

DocKtor

bdutchak@greatwest.ca · 10-10-2014, 10:31 PM

Laurence, I had the exact same problem. Just pull the power out for 5+ seconds and back in.

10-03-2014, 04:48 PM	#1
TargusLevel3 Member Join Date: Jun 2013 Location: California Posts: 56	Exchange If Its An ACP70 Laurence, I suspect you have a dodgy dock. That is, some ACP70 have an inductor value that has drifted over time enabling a ringing on a low power input rail to the DisplayLink device that will at times start and others not, an intermittent. I recommend you exchange the dock for a new one. Targus' factory has modified the hardware and fixed the issue. If it is not an ACP70, then post back. DocKtor

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

10-10-2014, 10:31 PM	#2
bdutchak@greatwest.ca Junior Member Join Date: Oct 2014 Posts: 2	Laurence, I had the exact same problem. Just pull the power out for 5+ seconds and back in.